Tamiya 71114 - Mechanical Blowfish  [71114]

The Mechanical Blowfish. Utilizing a crank and linkage pole system this robo-fish propels itself through water by its going tail fin. White under-belly holds the motor, gearbox, battery power field and switch and it is sealed water-proof tight. Components could be develop by snap-lock pieces or screws, and clear green back means you will see all the mechanics despite having summary.

Tail motion Gearbox transfers engine rotation to going end motion via crank and hyperlink rod. The gearbox plays the vital part of reducing motor cost, enabling splash free movement. Provides about 7 moments to swim 1 meter.

Water-Proofing Uses water proof taping and synthetic O-rings to stop water showing up through screw holes, on and off switch, end fin and joining line between top and bottom halves.

Swimming Control Pull the stopper positioned on foot of the tail and alter left or to control the swimming direction. The greater amount of you turn the stopper the higher the alteration in swimming angle. The end normally created from a straightforward to cut product, helping you to freely contour the tail for a lot of of good use swimming performance.

Specs & qualities

• total length: 197mm
• basic height: 81mm
• Body product: ABS resin
• Gearbox and engine included
• Tape and plastic o-rings regularly water proof body
• Screw motorist included
• needs one AA battery pack (sold individually)
• constant operating time with alkaline battery power: 4hrs