Tamiya 58268 - 1/20 RC Mammoth Dump Truck
This is the Tamiya 1/20th Scale electric, radio control Mammoth Dump Truck.
This durable kit is created regarding earthshaking mammoth dump cars found in major mining alongside high quality jobs.
FEATURES:
Effective shaft driven 4WD.
Two engines; one 540 size to push the tires; one smaller motor with worm gear shaft for dump human body operation.
Kit uses two channel radio for all functions, to enhance bed end automobile and steer well suited for several second, return steering
to fundamental to remove increasing, steer kept for bringing down. No need for costly three channel radios.
Fully practical dump body supports to 8.8 pounds (4kg) of product for dumping.
Durable die-cast gears housed appropriate ahead and back sealed gearboxes.
Four wheel suspension system system loaded with coil and leaf spring surprise devices.
Durable Juggernaut 2 Monster Truck chassis.
Cab and dump human body are molded in shock resistant plastic.
6-1/8" (156mm) diameter 2-3/8" (60mm) wide plastic tread tires pre- put up on synthetic metal finish tires.
INCLUDES:
One 1/20th Scale Electrical broadcast Control Mammoth Dump Truck with electronic rate control with Futaba J receiver plugs and Standard battery pack connectors, 6-1/8" (156mm) x 2-3/8" (60mm) plastic tread tires pre-mounted on plastic metal finish tires, one pipe thread locking element, one 4-way wrench, two pipes of grease, artificial ties, flat blade screwdriver, body pins, double sided tape, two hex wrenches.
NEEDS:
Broadcast: 2 channel pistol hold with two servos.
Battery: 7.2v flat stick pack.
Tools: big and tiny blade phillips screwdrivers, tweezers, modeling blade, very long nose pliers, component cutters, scissors, pin vise
and synthetic concrete.
SPECS: Length: 20-5/8" (525mm)
Width: 11-5/8" (295mm)
Height: 11-13/16" (300mm)
fat: 12.2 pounds (5.5kg)
FEEDBACK:
For replacement bearings use:
1- 5x8 Gear Assembly
3- 5x11 Gear Assembly
1- 5x8 countertop Gearbox
1- 5X11 countertop Gearbox
1- 6x12 Driveshafts
2- 6x12 front side Uprights
2- 6x12 rear Uprights
2- 3x7 Rack Gearbox
1- 5x8 Rack Gearbox
1- Tamiya MV1 4mm flanged steel bearing Rack Gearbox
2- Tamiya MV1 4mm flanged metal bearing L & R Rack Case Assem.
1- 5x8 L & R Rack Case Assembly
