Futaba 6EXAP 6-Channel FM 35Mhz/ R136F/ 4xS3003 [6EXAP_c5]

Price:

NZD$249.75

Brand:

Futaba

Model:

6EXAP_c5

Not Available

Please kindly input your name and email address, we will inform you once we have the restocking.

Or you may find similar product under the
R/C Models - System - Transmitter - Flight Transmitters category

Write a review

Description

FEATURES:

Aileron, Elevator and Rudder double price switch - use this modification to ��flip�� between two aileron, elevator and rudder control throw settings. The tosses are setup you need, but the majority of that time period, in the event that switch is ��up�� the throws are greater (��high rate��) the moment the switch is ��down�� the throws are less (��low rate��). This switch in addition flips between exponential rates (if utilized).
Flap control dial/Channel 6 - This dial operates the servo associated with channel 6 inside receiver in case your model has flaps here is the control used to function them.Aileron/elevator control stick -Mounting point for optional neck strap.
Trim levers (all) -Used to go the essential or center host to every servo as labeled inside diagram.
Asking jack - Port for recharging you the transmitter batteries aided by the included battery pack charger.
On-off switch
DATA INPUT lever - usually replace the values connected with various functions exhibited regarding LCD screen.
Liquid-crystal display (LCD) - shows development modes and values joined up with up with.
MODE key - accustomed scroll through and show the ten or eleven(PCM) various functions.
CHOOSE key - accustomed display the values the present function.
Throttle-cut button - to utilize the throttle-cut function, repaid the throttle stick completely, then drive the throttle-cut key to fully shut the carburetor and shut the motor.
Throttle/rudder control stick - operates the servos associated with channel 3 (throttle) and channel 4 (rudder) in receiver.
Trainer switch - operates the trainer functions. To utilize as a trainer switch the transmitter must certanly be associated with another transmitter via. a trainer cable (available separately).
Retractable landing gear switch/Channel 5 - modification runs the servo connected to channel 5 in to the receiver as soon as your model has retractable landing gear here is the control accustomed extend and retract the gear.
Antenna - Radiates signals towards the receiver. Cannot ever travel a model without totally expanding the antenna or perhaps you could produce disturbance to numerous other modelers and decrease practical indication range of the transmitter. The antenna could be eliminated and changed with another just in case its unintentionally broken.

Hot Brands

Futaba 6EXAP 6-Channel FM 35Mhz/ R136F/ 4xS3003 [6EXAP_c5]