Futaba 6EXAP 6-Channel PCM 35Mhz/ R146IP [6EXAP_c10]

Price:

NZD$224.93

Brand:

Futaba

Model:

6EXAP_c10

Not Available

Please kindly input your name and email address, we will inform you once we have the restocking.

Or you may find similar product under the
R/C Models - System - Transmitter - Flight Transmitters category

Write a review

Description

FEATURES:

Aileron, Elevator and Rudder twin cost switch - use this change to ��flip�� between two aileron, elevator and rudder control throw settings. The tosses are arranged you choose, but most of the time, following the switch is ��up�� the throws are greater (��high rate��) if the switch is ��down�� the throws are less (��low rate��). This switch also flips between exponential prices (if utilized).
Flap control dial/Channel 6 - This dial runs the servo attached to channel 6 in the receiver in case the model has flaps this is actually the control helpful to run them.Aileron/elevator control stick -Mounting point for optional throat strap.
Trim levers (all) -Used to go might or center host to every servo as labeled into the diagram.
Asking jack - Port for asking the transmitter batteries using the included electric batteries charger.
On-off switch
INFORMATION INPUT lever - always replace the values from the various functions exhibited regarding LCD screen.
Liquid-crystal display (LCD) - shows development modes and values joined up with with.
MODE key - always scroll through and show the ten or eleven(PCM) different functions.
SELECT key - accustomed show the values the existing function.
Throttle-cut switch - to utilize the throttle-cut function, paid off the throttle stick entirely, then drive the throttle-cut key to fully shut the carburetor and shut with this particular motor.
Throttle/rudder control stick - operates the servos related to channel 3 (throttle) and channel 4 (rudder) inside receiver.
Trainer switch - runs the trainer functions. To have results as a trainer switch the transmitter should really be connected to another transmitter via. a trainer cable (available individually).
Retractable landing gear switch/Channel 5 - modification operates the servo linked to channel 5 in receiver should your model has retractable landing gear this is actually the control constantly expand and retract kit.
Antenna - Radiates signals towards the receiver. Do not ever travel a model without entirely expanding the antenna or you may produce disruption to varied other modelers and decrease practical indicator selection of the transmitter. The antenna might be eradicated and changed with another in the case it is actually inadvertently broken.

Hot Brands

Futaba 6EXAP 6-Channel PCM 35Mhz/ R146IP [6EXAP_c10]