XRAY 303167 Graphite Rear Suspension Arm T2/T3 Performance Upgrade  [XR-303167]

XRAY 303167 Comp. Rear Suspension  Arm 1-Hole - Graphite
Price:
NZD$24.47
Brand:
XRAY
Model:
XR-303167
Condition:
Brand New
Write a review
alt="XRAY 303167 Comp. Rear Suspension  Arm 1-Hole - Graphite" title="XRAY 303167 Comp. Rear Suspension  Arm 1-Hole - Graphite"

Graphite rear arm built for T2 and T3 handling

The XRAY 303167 Graphite Rear Suspension Arm is crafted from a purpose-formulated graphite composite to give T2 and T3 drivers a reliable, lightweight replacement. It balances strength with reduced mass to suit competitive circuit use.

Traction gains and cooling advantages

This arm is aimed at improving traction and overall handling on grippy surfaces, helping to avoid excess tyre heat under race conditions. It uses a single shock position and integrated anti-roll bar mounts while matching the dimensions and geometry of a standard 1-hole suspension arm for an easy swap.

Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.
No special hardware is typically required; the arm uses the same mounting points and standard screws as the original 1-hole arm on T2 and T3 models.
Because graphite is lighter and stiffer, you may notice subtle handling changes. Expect crisper response and adjust suspension settings if needed to restore your preferred balance.
Clean off grit after outdoor running and inspect mounting holes for wear; avoid over-tightening fasteners to preserve the composite.
The stiffer graphite helps maintain suspension geometry, which can reduce heat buildup by promoting more even tyre contact under load.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved