XRAY 333712 Aluminum Rear Suspension Holder NT1 - Precision Tuning Part  [XR-333712]

Tune the NT1 Rear End

The XRAY 333712 Aluminum Rear Suspension Holder is built to refine NT1 rear suspension behaviour. By incorporating the rear bulkheads into a single holder, the part improves centring and enhances stability during fast track sections.

Bushings and Mounts for Adjustment

This holder uses square composite bushings from XRAY's T4 and XB4 platforms to keep vertical alignment of the inner hinge pins while allowing adjustments to pin width. These options let you dial in roll centre and refine your geometry setup for varied track conditions.

Closer Arm Spacing for More Grip

The reduced width of the aluminium holder enables the suspension arms to sit nearer each other, which increases rear-end traction. That compact layout suits drivers chasing stronger grip out of corners.