XRAY 372910 - X10'22 Aluminium Rear Bulkhead Right Side Track Spec  [XR-372910]

XRAY 372910 - X10\'22 Aluminium Rear Bulkhead - Motor - Right
Price:
NZD$82.54
Brand:
XRAY
Model:
XR-372910
Condition:
Brand New
Write a review

XRAY 372910 - X10'22 Machined Rear Bulkhead

The XRAY 372910 - X10'22 Aluminum Rear Bulkhead is engineered for precision and longevity on the X10'22 chassis. This right-side bulkhead is machined from quality aluminium to give a tight, dependable fit that stands up to track use.

Improved Rear Rigidity and Balance

The single-piece design boosts structural stiffness and lowers unwanted flex. A reduced-profile lower section and a revised upper plate lower the centre of mass, and locating pins on the top face keep the upper pod plate aligned under impact.

Simple, Accurate Ride-Height Changes

The bulkhead accepts eccentric bushings for straightforward rear axle height adjustments. Adjust in 0.5mm increments across 5mm of range so you can fine-tune balance and traction for different surfaces.

Specifications

  • Material: Aluminum
  • Compatibility: XRAY X10'22
  • Adjustment Range: 5mm (0.5mm increments)
  • Position: Right Side
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Can I run this with my existing rear pods?

If your rear pods are X10'22 specification, this bulkhead will fit as intended. Mixing parts from other years may require adapter pieces or modification.

Does aluminium change handling compared to plastic?

Aluminium increases stiffness and can sharpen the car's response. Expect more consistent rear geometry and reduced flex under load compared to standard plastic bulkheads.

Are the shims or bushings included?

Check the parts list from your supplier. The bulkhead accepts eccentric inserts but confirm whether the kit includes bushings or if they are sold separately.

What tools do I need to adjust the axle height?

Basic hand tools like hex drivers and a small punch or driver to turn the eccentric bushings are sufficient. A feeler gauge helps verify incremental changes.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved