XRAY 373089 X12'21 Race-Grade Graphite Rear Brace  [XR-373089]

XRAY 373089 - X12\'21 Rear Brace - Graphite 2.5mm
Price:
NZD$51.27
Brand:
XRAY
Model:
XR-373089
Condition:
Brand New
Write a review

Sharper Rear Control for Your X12'21

The XRAY 373089 X12'21 Graphite Rear Brace is built to tighten rear behaviour and minimise unwanted tweak. Crafted from 2.5mm graphite, it offers the right mix of rigidity and resilience to handle impacts while stabilising the rear pod.

Precision CNC Fitment for Rear Components

This brace is CNC-machined to secure side tubes, side springs and body posts, and it also acts as a battery stop to prevent pack movement during hard cornering. When added to an X12'21 chassis, it helps keep the rear suspension consistent lap after lap.

Engineered for On-Track Performance

Designed with racers in mind, the graphite rear brace improves chassis balance and rear traction without adding unnecessary mass. It helps drivers find a more predictable rear feel during fast sequences.

Specifications

  • Material: Premium-grade graphite
  • Thickness: 2.5mm
  • Compatibility: X12'21 Chassis

The XRAY 373089 X12'21 Graphite Rear Brace is a targeted upgrade to reduce rear tweak and stabilise handling. It suits setups where rear consistency is a priority for lap-time gains.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Does this brace change weight distribution?

The brace is lightweight and adds minimal mass, so it does not significantly alter weight distribution but can change rear feel by increasing stiffness.

Can I run this with stock springs?

Yes, it works with stock springs, though you may need to fine tune spring rates or preload to get the best rear balance after fitting.

Is additional machining required to fit?

No extra machining should be needed for a correct X12'21 chassis; the part is CNC-cut to match factory mounting points.

How often should I inspect the brace?

Check the brace after heavy impacts and during routine maintenance; inspect mounting screws and the graphite for surface cracks to avoid failures.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved